Cgminer raspbian download#

Download Win32 Disk Imager and use it to flash SD card with Raspbian.A HDMI to DVI / HDMI to HDMI cable (depending on your monitor).Edit nf using notepad, with your pool and miner information in it, an example as below.Download this specific version of cgminer and extract it.Once installed, you may have to restart.

Cgminer raspbian install#

Windows will try and install its own drivers.

Plug in a USB to mini USB cable from the HEX8A1 to your Windows based PC/laptop.

Click save and apply, then navigate to Status -> Cgminer Status to check mining has started.

Enter pool information and miner details as in the format below.

Find the IP the TL-MR3020 has now been assigned and navigate to that with a browser window.

Navigate to your router and look up list of clients.

(If applicable)At this point you can plug the TL-MR3020 back into your router and reset your computer settings.

Change protocol to DHCP client, click Save and Apply.

Navigate to Network -> Interfaces and click edit.

Navigate to 192.168.0.99/ from a browser window.

Select 'Use the following IP address' and enter the following:.

Click on 'Internet Protocol Version 4' and click properties.

Right click on your ethernet adapter -> Properties.

(If applicable) Right click on your wifi adapter -> Disable.

Navigate to Control Panel -> Network and Sharing Centre -> Change Adapter Settings.Plug in a network cable from the TL-MR3020 to your computer.

If this is not possible, see below indented steps. Change your router's subnet to 0, ie 192.168.Flash Technobit's custom WRT firmware (or purchase their preflashed TL-MR3020).Plug in your TL-MR3020's power cable - this can either be a USB to mini USB cable or mains to mini USB.Plug in a network cable from the TL-MR3020 to your router.Plug in a USB to mini USB cable from the HEX8A1 to the TL-MR3020. 4a) Con fi gur a tion (TL-MR3020) Īn external controller is required which can be a TP-LINK TL-MR3020 router, a Raspberry Pi with Raspian or a Windows based PC.